- Page 3 - Ford Transit USA Forum, 10 Things to Consider Before Using Shipping Containers For Your Project, Woman Converts Van Into a Cozy Full Time Home, Micro apartment turned into a family home with transformer furniture.

to this site, and use it for non-commercial use subject to our terms of use. Does it have any yet known waste hazards when no longer needed? Could it not be installed directly below the sheathing, between the rafters and then sprayed with foam? © 2016 JETSON GREEN | All Rights Reserved. Our Kraft facing is durable, resists tears, and is marked in 1 ft. increments to streamline installation. We are in NYC and I’d like to know how much you’re willing to let it go for! Thermablok manufactures aerogel in 1-1/2" wide strips rather than broad sheets. As well, you will have to make changes to the HVAC system to ensure proper air handling.

Aerogel insulation is also exciting because it provides good benefit with a thin profile. R38 is the bare minimum in Dallas per Code (IECC 2015) that has been recently adopted in Texas. best of luck OP and if you decide to diy or have. of Energy says up to R60 is cost effective.

god forbid you have to contact a distributor for a quote like you do with pretty much any industrial-market material. We'll assume you're ok with this, but you can opt-out if you wish.

In addition, EcoTouch® insulation: **Certified by Scientific Certifications Systems to have a minimum of 58 percent recycled glass content with at least 36 percent post-consumer recycled and the balance pre-consumer recycled glass content. A couple more questions.

Shared on @ThisBigCity This Week | This Big City, For those of us who are not engineers.

A well-insulated home can save up to 15% on heating and cooling costs while providing exceptional sound control performance. Â, Link to Lowe's Home Improvement Home Page.

Aerogel is indeed extremely water absorbing!!! How to Increase the Interior Ceiling Joist for R38 Insulation. Regarding foam board, is there a cross section photo that I could reference to see how it's installed? Now that I see it, I agree that spf is the best approach.

I wasn't home when these were delivered but many of the bags of insulation were cut in many different areas instead of only having one side open.

I'm planning a project to convert some attic space into a livable area. That option isn't possible now. I did a Google search on "thickness of r-38 batt insulation" and it said it would be approximately 6.25" thick. I still don’t know where to buy it from all these posts. and 0.40 in. My home was built in 1979 with approximately 8" of blown-in insulation (Virginia Climate). Especially read up on how to handle vapor barriers in a mixed humid environment. It looks like spray gives the highest R-value at the lowest thickness. Depending on your roof, it may be more economical to add foamboard insulation above the roof than spray under the sheathing. Lmao I think that was a joke. ArpaE should be investing in research to develop cheaper manufacturing methods of this type of product and get it out there. […] stuff (http://www.jetsongreen.com/2010/02/a…nsulation.html) is very expensive but it might not be cost prohibitive for reducing conduction from metal bridges […]. Mehr erfahren. That equals to 26 1/2 bags, so 27 should do.

Thank you.

Is it still available? The thinnest I saw was 3.5-4". Now, with colder weather kicking in, the house sits at 74 with the outdoor temp at 47, and the heater rarely turns on.

How does one break it down for recycling?

x 48 in. It will help reduce monthly heating and cooling costs for the life of the home and offers exceptional thermal and sound control performance.

Products shown as available are normally stocked but inventory levels cannot be guaranteed, For screen reader problems with this website, please call 1-800-430-3376 or text 38698 (standard carrier rates apply to texts). Owens Corning Blown In insulation is a DIY-friendly option best for adding insulation in an attic and can be installed on top of existing insulation in less than 1.5 hours Shop recommended products for … If you failed to insulate under the slab, you will want to extend that foam sheathing down below the soil level by at least 24" in your climate, incorporating that with your water management system and perimeter drain. Is this even remotely possible? That doesn’t mean you’ll be able to go order it off of Amazon, but you can most definitely buy it.

cell. ?? Does this material have any sound-insulation properties? I am only trying to have information to protect mother earth from more pollution products. You've over engineered and under engineer items at a much greater cost than if you had chosen the correct systems approach. According to Martin LaMonica of CNET, Spaceloft blankets have been used by the Rhode Island Housing Authority to retrofit a 50-unit housing complex that was built with no insulation in the 1940s.

I read in a do it yourself article that R-38 fiberglass insulation is avail... Hey guys, new to the forum.